www.flightsim4fun.com - rksoftware

Hi all After some further investigation I have found a solution. First, I had to notice: Trim wheel speed and range are dependent from flaps. With flaps up the range is restricted to ~ 3.95° - 14.5°, the rotation speed is quite low. With flaps extended, the speed is rather fast and the range from 0°...

Hi Roar and all I tried to optimise my stabiliser trim wheel in my PMDG 737-800. Up to now, I controlled the wheel in the virtual cockpit (VC) by the switches on the steering wheel, sending NUM1 and NUM7 keys to MSFS. The SW position was then copied to my HW wheel. The problem: I could not operate t...

Hi Roar and all Since some time there is an additional button on the chronos of the B737-800 named TC/SR, that offers an easy way to control time compression manually by 2, 4, 8,... or automatically by a predefined value (FMC configured). Of course, this button is not present in the real airliner an...

See the following discussion in the PMDG forum:
https://forum.pmdg.com/forum/main-forum ... dby-gauges

Perhaps you can add your own comment there and lift the thread again to top. The more we are the better our chance to get it.

Best regards
Urs

Just another hint: in FSUIPC you can read the variable 6438 and it outputs the value 195 (in a range of 0 to 240), that corresponds to the screen value of around 1600 psi. That means that NGX does the job already.

Best regards
Urs

Well, in the PMDG SDK you find: // Oxygen unsigned char OXY_Needle; // Position 0...240 bool OXY_SwNormal; // true: NORMAL false: ON bool OXY_annunPASS_OXY_ON; and the first line is probably connected to Var 1024. But the value is always 0, meanwhile the gauge on the screen shows about 1600 psi. Tha...

Hi Roar In the meantime my cockpit works really fine with OCP4NGX. But there is still a small problem. I don't get data for the oxy-needle in the aft-overhead. All other servos work fine besides the crew oxy. Is it possible that NGX or OCP does not provide this data for Var 1024? It is always on 0. ...

Hi Roar I am doing some SIOC optimisations for my B737. I would like all displays off at powerup. But the radios (COM1, COM2, NAV1,...) and the clock displays all show 8888... They only change, when SIOC is started after P3D startup. Other diplays start in the dark state, like the AC/DC and the IRS ...

Hi Roar and all In the meantime I had a closer look to the run command in AHK: Run, Target [, WorkingDir, Max|Min|Hide|UseErrorLevel, OutputVarPID] And now it is clear. I have to specify the WorkingDir, separated by a comma, then everything works fine. See the working code snippet: run C:\SIOC\sioc....

Hi Roar I am on the final for my B737 homecockpit. Since I have several programs to load after P3D to connect hardware and software, I am looking for an automised start sequence. I use the very versatile AHK program for that. I am quite successful with it, but now I have a problem, when I try to loa...