Hi,
Can anyone talk me through a setup and calibration for the USBServosPlus with the new style scripts (6.1) for MSFS. I had mastered the old P3d (script 5.5) style setup of initial point of reference and editing the scripts for that value, then changing the multiplier to adjust the amount of servo arm throw / calibration factor.
The new scripts look completely different and are giving me some strange results in that the FS values and what the needes are showing are way out. I've only altered the L C and R values in the initial outputs device, is this correct?
Also in the USBServosPlus application should I be setting the servo limits upper and lower in that so that the needles dont top or bottom out or should I just be letting them run full range 0-1023
Any help would be appreciated,
Many Thanks.
James
Servo Setup USB Plus
-
- Posts: 52
- Joined: Tue Jun 30, 2020 4:26 pm
- Location: Guildford
Servo Setup USB Plus
- Attachments
-
- Screenshot (5).png (242.19 KiB) Viewed 1342 times
James Curry
Loadmaster
Loadmaster
Re: Servo Setup USB Plus
Check this topic. It will give you some information on how to calibrate the gauges.
viewtopic.php?t=1083
viewtopic.php?t=1083
-
- Posts: 52
- Joined: Tue Jun 30, 2020 4:26 pm
- Location: Guildford
Re: Servo Setup USB Plus
This is absolutely fantastic guide and just what I was looking for,
Many thanks @mvr1918 for the link
Many thanks @mvr1918 for the link
James Curry
Loadmaster
Loadmaster
Re: Servo Setup USB Plus
You are welcome.