fueltemp servo needle static position issue.
Posted: Sat Nov 25, 2023 3:16 pm
Hello,
I have a problem regarding the static position of the fueltemp needle on my overhead to work.
the gauge/needle work as it should while operating the 737, but when I am exiting the sim the needle always stay where it was prior to exiting the sim.
I have tried inputting different values in the VAR 1056 static value but with no results at all. The needle will just stay where it was when exiting.
can someone see if I am doing something wrong out from the picture I captured from my sioc script? any help is apriciated!
BR Tom.
I have a problem regarding the static position of the fueltemp needle on my overhead to work.
the gauge/needle work as it should while operating the 737, but when I am exiting the sim the needle always stay where it was prior to exiting the sim.
I have tried inputting different values in the VAR 1056 static value but with no results at all. The needle will just stay where it was when exiting.
can someone see if I am doing something wrong out from the picture I captured from my sioc script? any help is apriciated!
BR Tom.
- ft static.png (124.74 KiB) Viewed 2169 times