www.flightsim4fun.com - rksoftware

Hi,
I have just tried flying with the Airbus and for some reason the MCP, EFIS and Com have stopped communicating with the sim. I only see 999 in the MACH and zeros in all the other screens. If I adjust the altitude etc on the MCP the numbers do change but not in the sim. I have tried uninstalling the airbus modules from the sioc folder and putting them back in, tried editing the FSUIPC.INI file again but still the same.
I have noticed that when I pick the Config for the Aerosoft Airbus I just see MASTER,15,5,1,51 in the active cockpit field, is this correct?

By the way the 777 and 737 are working fine so its not a problem with my computer seeing the MCP etc.

Any help would be appreciated.

Thanks

Keith

Hi,


You should have a this in the ssi.ini and AEROSOFT AIRBUS.ini file after running OC4BAv4/Config
[*]
[AEROSOFT AIRBUS]
CONFIG_FILE=OCP4ABX_V1.1.ssi
MASTER = 15,5,1,51

How to install:
1) Unzip driver file OCP4ABX.exe, document files and script file OCP4ABX_v1.1.ssi to SIOC folder
2) Unzip the 3 lua files to MODULES folder in your FSX/FSX-SE/P3D main folder.


Go to FSX/FSX-SE/P3D/MODULES folder and open FSUIPC.ini file

paste in the text:

---from the line below this line--

[Auto.Airbus x]
1=lua ocp4abx_m_v1.1
2=lua ocp4abx_mc_v1.1
3=lua ocp4abx_e_v1.1


[Profile.Airbus x]
1=Airbus A3

-- including the line above this line--

Also chech that you have the line

ShortAircraftNameOk=Substring

3) Save FSUIPC.ini

How to configure:

1) Open OC4BA v3 from SIOC folder

2) Go to OC4BAConfig by clciking the Tool symbol

- Select AEROSOFT AIRBUS as Cockpit, then select ocp4abx_v1.1 as script
- the P&P MCP, EFIS, FMC should pop up ( if these are the modules you have)

Thanks Roar,
I had some entries in the INI files under the MASTER entry. I deleted these and now all is fine.

This topic is marked as SOLVED