Page 1 of 1

No digits in MCP or ATC modules, help![SOLVED]

Posted: Mon Feb 06, 2017 5:56 pm
by dornier
Hi,

No problems with the 737 and 777, but with the 747 I get no digits on the MCP or ATC modules. Any ideas?

Thanks,

George

In case it helps, here's the ini file:

[SIOC]
IOCP_port=8092
IOCP_timeout=4000
Minimized=Yes
toggle_delay=20
[IOCARDS MODULE]
IOCard_disable=No
IOCard_LPT=No
[FSUIPC MODULE]
FSUipcdisable=No
FSUipcRefresh=60
[IOCP CLIENTS MODULES]
IOCPini_delay= 3000
IOCPclient0_disable=yes
IOCPclient0_host=localhost
IOCPclient0_port=8099
IOCPclient1_disable=yes
IOCPclient1_host=localhost
IOCPclient1_port=8092
[SOUND MODULE]
Sound_disable=Yes
Volume=100
[*]
[PMDG B747]
CONFIG_FILE=OCP4747X_v4.0.ssi
MASTER=7,7,1,58
MASTER=11,11,1,68
MASTER=15,15,1,60
MASTER=13,13,1,47

Re: No digits in MCP or ATC modules, help!

Posted: Mon Feb 06, 2017 7:07 pm
by Ashoka
Hello,
I have the same problem, no digit and the altitude's knob doesnt work.
Thank's

Laurent

Re: No digits in MCP or ATC modules, help!

Posted: Mon Feb 06, 2017 8:57 pm
by dornier
Found it! You have to edit the 747QOTSII_Options.ini file in the PMDG root directory for the 747 and add these lines to the end of the ini file:

[SDK]
EnableDataBroadcast=1

Then it worked.

Hope this helps,

George

Re: No digits in MCP or ATC modules, help!

Posted: Mon Feb 06, 2017 9:09 pm
by mvr1918
Sorry for not telling this in the MUST READ OCP4747X file.

add these 2 lines to the 747QOTSII_Options.ini file:

[SDK]
EnableDataBroadcast=1

to enable the aircraft data sending from the 747QOTSII.


But, I thought you all read the detailed documentation from PMDG before you jumped into the Captain seat and took off.

Not reading the documentation and manuals for this airplane before first flight would have got you fired from the company and back to office work :)

Re: No digits in MCP or ATC modules, help!

Posted: Tue Feb 07, 2017 4:45 am
by Ashoka
Thanks guys, it works fine!
Mea culpa... :(

i'm go back to office work! ;)

Re: No digits in MCP or ATC modules, help!

Posted: Tue Feb 07, 2017 6:19 pm
by mvr1918
i'm go back to office work!
You are welcomed!