NAV1 and NAV2[SOLVED]

[ose159]

Hi,

i have installed your program and i had to duplicate the opencockpit nav modules and now i have NAV1 and NAV2 correclly recognized.
The problem is that i have to switch few times between stand-by and active frequence before getting the right digits on the active display.
I do not understand why, In these few attempts, i get wrong indications.

Example

at the start up i have : active 118.20 stand-by 116.00
transfer : active 111.23 stand-by 118.20


Thanks in advance
Claudio Damiani

[mvr1918]

Nor sure I understand "duplicate the opencockpit nav modules". Both NAV1 and NAV2 are scripted in the OCP4NGX_v4.6.ssi file

[ose159]

Hi,
when i started the configuration i had just one NAV in the ACTIVE COCKPIT column even if both NAV1 and NAV2 where pluged in the USB port.
I then had to select the NAV2 from the OPERATIONS column and so i had in the ACTIVE COCKPIT NAV1 and NAV2 .
At this stage the NAV1 was off so went to the MASTER instructions and i realized the both NAV were assigned to port 38 but one was really connected to port 38 and the other one to 39.
So i modified the PMDG ini file specifing 38 and 39.
At this stage both of them were working even with problem i described at the beginnig.
Do not exitate to contact me if more info are required.
Thanks in advance
Claudio Damiani

[ose159]

Hi,

i solved the problem this topic can be closed
Thanks
Claudio Damiani

[mvr1918]

Solved by TS