www.flightsim4fun.com - rksoftware

Hi, I'm getting back after a few years to this and just installed the P3d V5, oc4bav5 and Pmdg 737 Ngxu, followed all the video instructions, the mcp shows all the numbers correct when I change them in the sim but the dials are all over the place, with the overhead same thing. I watched all the how to videos but I can't figure it out. Is there a different script for ngxu? Or what am I doing wrong? Not good at programming, is there any video to set up the nxgu?. A few years ago I had de v4 for ngx and it worked fine. Just can't get this one to work. Any help would be appreciated.
Thanks.

Welcome back to flight simming:)

The script are the same for both NGX and NGXu, but the drivers are different.


Have you checked the NGXu in the OC4BAv5 main window, so you load the correct driver for ngxu?