www.flightsim4fun.com - rksoftware

I have the problem too. I mentioned it in my first post on this forum.

viewtopic.php?p=4248#p4248

I haven’t been on the sim for some months now, but I assume the problem is still there. I will have to look.

Regards.

Ian

SIOC events for STAB_TRIM SWITCH on PEDESTAL 2727 = STAB_TRIM_OVRD_SWITCH 2728 = STAB_TRIM_OVRD_SWITCH_GUARD SIOC events for CONTROL STAND STAB_TRIM 2347 = CONTROL_STAND_STABTRIM_AP_SWITCH 2348 = CONTROL_STAND_STABTRIM_AP_SWITCH_GUARD 2349 = CONTROL_STAND_STABTRIM_ELEC_SWITCH 2350 = CONTROL_STAND_S...

Hi All Not too sure where to post this as there isn't a SIOC section on the forum, but I found this on a Flight Sim related site, and thought it might be useful to anyone trying to understand SIOC. This was the script, with annotations explained below. ///////////////////////////////////////////////...

Thanks very much for the information. Where do you get the variable numbers from? Are they specific to your software or can any numbers be used providing it’s not duplicated? I have two additional annunciators on my MIP, which aren’t standard from Opencockpits. They’re the Take Off Config & Cabi...

Hi All I'm trying to write a script for my TQ. It uses the Opencockpits DCMotorPlus card, which I have assigned as IDX 14. I'm finding SIOC rather confusing. I've looked at the SIOC tutorial on Lekseecon website, and the example given for a 2 way switch is written as: Var 1 Link IOCARD_SW Input 23 T...

Sorry.

The attachment didn't load. It gave a HTTP error.

Should be attached now.

Regards.

Hi All When I first built my sim I used FSX and Prosim737, which I still have, although it's an old version 1.56. I would like to try and use the Prosim display panels on the sim as they're configurable and will be saved wherever they're positioned. And they're much better quality than the PMDG 'pop...

I'm hoping to sort a script for the OC motorised throttle. But all needed Control Stand Events and Variables are available in the driver code, so a user can write his own script and embed that with the defaul PMDG 737 script. How do we get these Events & Variables from the driver code? Regards Ian

Skycowboy wrote: ↑Thu Feb 09, 2023 10:56 pm But, if I try to switch the engine start switches to CONT I feel a resistance and it's impossible to switch it.

Hi Rolf

Are the servo's retuning to a 'FREE STATE' meaning the starter switches are able to move freely, and not being restricted by the servo?

Regards

Ian

These are inputs, but the assigned numbers are not correct. They exist in the PMDG 737 SDK as inputs and also in the virtual cockpit. I do not have the factory built MIP, but a self built MIP based on IOCARDS. They were in use there. Not tested now in MSFS as I do not have the MIP up and running. M...